ABSTRACT: The structural strength of soils has been extensively described by physical and mechanical properties evaluated on the mesoscale for different soils and management conditions. However, changes in the organization of the soil matrix at the microstructural level, which can be obtained by rheometry, are still seldom used in soil mechanics. Our aim was to use the amplitude sweep test, a rheometry technique, to investigate the microstructural strength of four subtropical soils (two Oxisols, an Ultisol and a Vertisol) and to discuss difficulties with respect to the samples, water content, soil density and vertical force. The various rheological properties which reveal the soil microstructural strength were determined: deformation at the end of the linear viscoelastic range, LVE range (γLVE), shear stress at the end of the LVE range (τLVE), deformation at yield point, YP (γYP), storage and loss moduli at YP (G′G″YP), maximum shear stress (τmax), and integral z. In general, soil elasticity (γLVE and γYP) and microstructural strength (τLVE and τmax) were greater in the Oxisols and the Vertisol, which both possess high clay content, while the latter also contains expansive clay minerals. The lowest structural strength was observed in the Ultisol which had a high sand content. As rheological properties are related to soil properties such as particle size distribution and carbon content, they can be applied in the evaluation of the microstructural strength of clayey and sandy soils and allows for inferences regarding inter-particle shear strength. However, the test is not applicable to very dry soil samples and sample preparations can affect the results. We suggest a number of approaches to find solutions for these difficulties/problems.

ABSTRACT Rheological parameters have been used to study the interaction between particles and the structural strength of soils subjected to mechanical stresses, in which soil composition and water content most strongly affect soil resistance to deformation. Our objective was to evaluate the effect of water tension on rheological parameters of soils with different mineralogical, physical, and chemical composition. Surface and subsurface horizons of four Oxisols, two Ultisols, one Alfisol, and one Vertisol were physically and chemically characterized; their rheological parameters were obtained from amplitude sweep tests under oscillatory shear on disturbed soil samples that were saturated and subjected to water tension of 1, 3, 6, and 10 kPa. In these samples, the rheological parameters linear viscoelastic deformation limit (γL), maximum shear stress (τmax), and integral z were determined. By simple regression analysis of the rheological parameters as a function of soil water tension, we observed increased mechanical strength with increasing water tension up to at least 6 kPa, primarily due to increased capillary forces in the soil. However, increased elasticity assessed by γL was not as expressive as the increase in structural rigidity assessed by τmax and integral z. Elastic deformation of the soil (γL) increases with the increase in the number of bonds among particles, which depend on the clay, total carbon, expansive clay mineral, and cation contents; however, maximum shear resistance (τmax) and structural stiffness (integral z) mainly increase with clay, kaolinite, and oxide content by increasing the strength of interparticle bonds. A decrease in mechanical strength occurs for water tension of 10 kPa (the lowest water content evaluated) in sandy horizons or in horizons with a high proportion of resistant microaggregates (pseudosand), when associated with low bulk density, due to fewer points of contact between soil particles and therefore lower capillary force.